Hey Everyone,

 

Just like the title says. I have my SECL setup to be a traffic advisor and it disables at stage 3. Is it possible to just add to the line to disable at stage 2 as well?

 

Also bonus issue/help needed if you can:

My environment lightning for extra 2 and 3 are facing backwards of where the light heads are aimed at. Is this just simply needing to move the dummy back farther and down just like extra 11 needs sometimes?

 

Thanks,

Thero

Edited February 22, 20188 yr by Thero

On 2/22/2018 at 2:43 AM, Thero said:

Hey Everyone,

 

Just like the title says. I have my SECL setup to be a traffic advisor and it disables at stage 3. Is it possible to just add to the line to disable at stage 2 as well?

 

Also bonus issue/help needed if you can:

My environment lightning for extra 2 and 3 are facing backwards of where the light heads are aimed at. Is this just simply needing to move the dummy back farther and down just like extra 11 needs sometimes?

 

Thanks,

Thero

I don't think environmental lighting is actually controlled by the dummy position, the dummy determines where the corona is when you are a certain distance from the vehicle. To set environmental lighting, you should edit the coordinates at the top of the vcf for each of the extras. I do this based off the location of the dummy as shown in the properties in zmodeler. And make sure you adjust which axis and whether a value is positive or negative based on the different axis in zmodeler vs openiv; coordinates in the vcf should be according to the openiv axis orientation

5 hours ago, willrs said:

I don't think environmental lighting is actually controlled by the dummy position, the dummy determines where the corona is when you are a certain distance from the vehicle. To set environmental lighting, you should edit the coordinates at the top of the vcf for each of the extras. I do this based off the location of the dummy as shown in the properties in zmodeler. And make sure you adjust which axis and whether a value is positive or negative based on the different axis in zmodeler vs openiv; coordinates in the vcf should be according to the openiv axis orientation

Cool deal. Thank you for replying back and helping me out with it.