Hello,

I am making an ELS Arrow board type part and i'm running into the problem of it not opening all the way. Everything works perfectly but it stops halfway. Is there anyway to increase how much the part rotates?

 

Hi,

select the bonnet/boot dummy, go to the Properties Tab. At the end of the list, double click on User-Defined options. One value should be 0,70 or something close, increase it to 0.90 and you're done.

1 hour ago, Sentinel55 said:

Hi,

select the bonnet/boot dummy, go to the Properties Tab. At the end of the list, double click on User-Defined options. One value should be 0,70 or something close, increase it to 0.90 and you're done.

Should it be 0,90 or 0.90?

0, 90

2 minutes ago, Sentinel55 said:

0, 90

I tried that for the value on RotY and it had no changing effect. 

Make sure to click on Apply when you're done. It's right below the User-defined Options.

11 minutes ago, Sentinel55 said:

Make sure to click on Apply when you're done. It's right below the User-defined Options.

I did, I also isolated it. 

I'll gladly take a look at your problem in Zmodeler. 

FIgured it out, it was being applied to the part but not the dummy.