I'm trying to do up a K-9 CVPI but I'm having trouble with the pre-existing seating in the back of the car? As I'm fairly new to modding cars I don't know how to insert it. Do I remove the back seat? (no clue how to do that either), do I place the K-9 cage on top of the back seat and scale it into position? Or is there another way of doing it. 

If you have any idea on what to do could you tell me please.

 

Cheers, 

Hank Voight

As far as I am aware, the entire rear seating area is removed.

As far as I am aware, the entire rear seating area is removed.

 

I thought it must have been, I just have no idea how to remove the back seat in Zmodeler 

Using the "Separated" selection tool while in Polygonal mode would probably be the most efficient. Just be aware that a lot of models may not have anything under/behind the rear seats, leaving an open hole.

Using the "Separated" selection tool while in Polygonal mode would probably be the most efficient. Just be aware that a lot of models may not have anything under/behind the rear seats, leaving an open hole.

 

Thanks for the tip!