So I've tried to troubleshoot and have found whats causing my issue in regards to traffic. Randomly last night, when I go Stage 3 lighting, traffic automatically slams on the breaks despite no siren being on. I checked my settings, "Lstg3LightsMoveTraf = off " so its not that command. I found that when I change [ PRML ] type from leds to drot, this causes the traffic to stop based on just lights. Is this a built-in thing for drot lighting? Am I missing another setting causing traffic to stop based on Stage 3?

Also to note, I was using ?do=embed' frameborder='0' data-embedContent> for the models and their ELS config files. I went piece by piece from the default config of ELS and the issue pops up once I arrive to the primary lighting


No one knows if its intended for 'drot' lights to move traffic without the use of a siren? I've gone over the manual a few times and there's no mention of such a function.

Edited July 31, 201411 yr by ineseri
Use the edit button to add more information to your post

I'm using the same pack and having the same issue..:/

Just adds some realism!

SIs this a built-in thing for drot lighting?

-snip-

No one knows if its intended for 'drot' lights to move traffic without the use of a siren? I've gone over the manual a few times and there's no mention of such a function.

Yes, it's an intended function... of vanilla GTA4.

DRot uses siren dummies to rotate around a steady-burn extra.

Vanilla GTA4 for POLICE/POLICE2 use siren dummies to give the illusion that the rotators are reflecting the coronas.

Because it's using vanilla GTA4 behaviour, it is technically functioning as Rockstar intended.