I made a model and installed a handling line of Sgt. Kanyo for it, but the following happens while driving:

 

http://www.youtube.com/watch?v=fbkjzTdWAqA&feature=youtu.be

 

 

 

These are the handling lines used:

 

1777.0 0.33 85 0.0 0.0 -0.25 0.0 4 0.128 1.0 260 0.52 0.67 0.7 33.0 1.45 0.95 14.0 0.11 0.47 2.5 1.7 1.7 0.1 -0.08 0.0 0.49 2.0 1.0 2.2 2.5 0.0 25000 400010 0 0

 

1777.0 0.33 85 0.0 0.1 -0.32 0.0 4 0.127 1.0 260 0.52 0.67 0.7 33.0 1.5 0.95 14.0 0.11 0.47 3.2 2.0 2.0 0.1 -0.07 -0.005 0.5 2.0 1.0 2.2 1.5 0.0 25000 400010 0 0

 

 

I would rally appreciate it if someone helps me out (and moves it whe it's in the wring section)

Does this only happen when using the handling line? Or all the time? You possible moved the wheel when you made the model, check and make sure the axis of the wheel is directly over the axis of the wheel_lf dummy. Center the axis on the wheel if its not already and you'll be able to line it up if its off center. Have you modified the vehicle.ide of the slot you have the car in?  

I only changed the handling line, but I'll check the axis

 

 

EDIT: Could the problem be caused by the pushbar, because the same car without the pushbar works fine :S

Edited April 21, 201313 yr by ScrimpyData