I know requests are usually frowned upon communities like this but I figure it couldn't hurt to ask.

 

Awhile back ago I inquired about fixing the ingame cowboy hat to properly fit the police man model and I was told I couldn't do it in zmodeler because the file type wasn't supported. So I'm hopping someone has the time to adjust the position of the hat to fit correctly. Basically the hat just needs to be moved forward a bit.

 

 

I also have a 3D model of a Ford Ranger, while I'm decent with Zmodeler I don't have the skill level to get this to a level of being converted. I'm just hoping someone is interested in tackling this for me.

 

 

Hopefully someone takes notice of these suggestions and takes them up!

For the hat, just use this: '?do=embed' frameborder='0' data-embedContent>>.

 

The ped models should be the same, so the hat included in that file should fit just fine. But you might have to retexture it depending on your taste.

I've used the campaign hat before and I do like the campaign hat, but I feel like its too formal for the "small town sheriff" look. I use the campaign hat for the state troopers though. I guess I'm just being really picky :P