Hey, I'm making an undercover car with a visor light but the visor keeps rotating after I put it down. I believed I followed the els instruction correctly but I don't know what the problem is? The links show the the part in the vid where it keeps rotating, and the zmod setup.

 

Did you perhaps forget to input a limit for rotation in the returning animation (or too high of a value)?

 

Cool light setup, btw, especially the lights on the visor that actually flips down.

Edited March 28, 201511 yr by iansonwheels

Did you perhaps forget to input a limit for rotation in the returning animation (or too high of a value)?

I didn't even know that I had to do that. Where would I find this value, zmodeler, the els config?

I didn't even know that I had to do that. Where would I find this value, zmodeler, the els config?

 

Probably ZModeler, since I don't think there is a section in any of the ELS configs for that (and it's the visor object itself).

 

However you setup the animation, I would expect there to be some editable values in the options for it.

Probably ZModeler, since I don't think there is a section in any of the ELS configs for that (and it's the visor object itself).

 

However you setup the animation, I would expect there to be some editable values in the options for it.

http://gyazo.com/6739544a1f702bbfa8f6040cdd8fc5abThese are the values I found when I looked at the properties for the sphere dummy, I don't think any of them are helpful though

Did you figure this out?