So i ran across this problem after adjusting my lightbar and changing the UV mapping on the CVPI that i am currently working on, it worked just fine and then after that it just hung itself and didnt want to export my model anymore. i have my hierarchy posted down below so that you can take look at it and see if there's an error anywhere, i've tried the base things such as changing from .PNG to .DDS and i have tried including the texture while exporting and not including them, still not worked and i am just minutes away from punching my monitor since i can't find the problem. 

 

'>

 

'>

 

 

Any ideas? 

 

 

That would most likely be the prisoner divider you are using. I've alway had problems with it. No matter what car I put it in, it always crashed zmod on the export. I'd recommend using a different divider.

I tried removing the divider, and it still doesn't work, me myself have never had any problems with it in cars i've done in the past but it was worth a shot, it must be something else that isnt right with it 

quick update: i will redo the things i did before, found a savefile that i had saved it in but in an earlier stage, so i will come back with (hopefully) good news 

Alright, so i don't know what i did before but i must have messed up something, its now working!  a tip for everyone, if this happens to you to, just try and load an earlier save and do everything over again... thanks for the contribution Fox, might be a good thing to watch out for! 

Thanks for the answer OverPower.