Hello,

is there any way at all to rotate an arrow board and ideally to have it flash without els. At the very least, just rotate it?

I was fiddling with the two truck, to see if I could find the mechanism it uses, but no luck

I was also looking at how to extend the arm rotation of it was possible 

21 hours ago, Mcpba said:

Hello,

is there any way at all to rotate an arrow board and ideally to have it flash without els. At the very least, just rotate it?

I was fiddling with the two truck, to see if I could find the mechanism it uses, but no luck

I was also looking at how to extend the arm rotation of it was possible 

I do not believe this is possible, if you wanted to use a Non-ELS Arrow, it'd most likely have to flash on both sides. ELS would be needed to make it flash in certain directions. 

I’d be fine with flashing in both directions, or it not flashing at all. I’m sure there is a way, someone just needs to figure out how to modify the settings I mentioned above.

I only really care that it raises 90 degrees and lowers back to where it was